Follow us on
Macroza Facebook Macroza You Tube Macroza Flickr Macroza Vimeo
 
Products > MACROZA Milling Cutter > Milling Cutter Sharpening

It is very important to keep the milling cutter sharpened at all times. A blunt milling cutter will not cut, but hit against it instead transmitting vibrations to bearings and pinion that may lead to motor failure.

Use the MACROZA Carbide Tester before sharpening the milling cutter to check whether the carbide teeth need to be sharpened.

To sharpen a milling cutter use an emery or grinding stone with the following specifications: Silicone Carbide, Grain 80, and Grade JK.

Only sharpen the tooth’s top part. Never sharpen the front part. Sharpening the milling cutter will take no longer than 2 minutes.

Carbide tester
Sharpened Blunt

Video Milling Cutter Sharpening



Macroza S.L. | C/ Leñeros 15 - 28039 Madrid | Tel: (+34) 91 541 92 94 | Fax: (+34) 91 542 86 08
Legal Disclaimer
Copyright 2013 Macroza | Wall Chasers
Macroza Facebook Macroza You Tube Macroza Flickr Macroza Vimeo