Follow us on
Macroza Facebook Macroza You Tube Macroza Flickr Macroza Vimeo
 
Products > MACROZA Milling Cutter > Installing and Removal

Milling Cutter installing

- Only original MACROZA milling cutters should be used as they are specifically designed for our MACROZA wall chasers

- Make sure the MACROZA wall chaser is switched off and unplugged from mains power before handling the milling cutter.

- Before installing the milling cutter it is very important to place a washer (supplied with the machine and cutters) between the shaft and milling cutter. This will ensure perfect seating on the shaft and will make it easier to remove the milling cutter after use.

- Install milling cutter leftwards with teeth in cutting position as indicated on the arrow engraved at the milling cutter cover.


Milling Cutter removal

- To remove milling cutter, use spanner and the special wrench supplied with our MACROZA wall chasers.

- Fix the spanner between the shaft and milling cutter cover. Loosen with the special wrench, hooking it onto the lower tooth and the opposite lip.

- Hit with hand or hammer the special wrench once attached. Do not hit the special wrench if the spanner is not fixed between the shaft and milling cutter cover.

- See milling cutter removing steps on the right hand side pictures.

STEPS:
- Fix shaft with spanner
- Use supplied wrench
- Hit special wrench once...
Macroza S.L. | C/ Leñeros 15 - 28039 Madrid | Tel: (+34) 91 541 92 94 | Fax: (+34) 91 542 86 08
Legal Disclaimer
Copyright 2013 Macroza | Wall Chasers
Macroza Facebook Macroza You Tube Macroza Flickr Macroza Vimeo